
26
Enter Setup
Scanner Configuration SmartScan Manual
4.3 CODE 25 PARAMETERS
4.3.1 INDUSTRIAL 25
Serial Command
0080
Serial Command
0081
<Enable> Disable
START / STOP PATTERN SELECTION
Serial Command
0130
Serial Command
0131
<Industrial 25> Interleaved 25
Serial Command
0132
Matrix 25
CHECKSUM VERIFICATION
Serial Command
0139
Serial Command
0140
Enable <Disable>
CHECKSUM TRANSMISSION
Serial Command
0141
Serial Command
0142
<Enable> Disable
CODE LENGTH QUALIFICATION
1) Read the label to enable either Max. /Min. length qualification or fixed length qualification.
2) Read the labels for Max. /Min or fixed length separately.
3) Read the “
Decimal Value” label on page 57 for the desired inter-character delay (millisecond).
4) Read the “Validate” label on the same page to complete this setting.
Serial Command
0208
Enable Max./Min. Length …
Comentarios a estos manuales