CipherLab 1520 Guía de usuario Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 87
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
19
Chapter 2 Barcode Settings
Vibrator
Specify how long the vibrator is turned on (in units of 0.1 second) to indicate a barcode has been
read successfully.
By default, the vibrator is turned off.
2.3.4 ALARM (ERROR FEEDBACK)
When an error occurs, the mobile computer may inform you by issuing a beep or
vibrating.
Beep Sequence
A beep sequence refers to pairs of Beep Frequency(x) and Beep Duration(y). You may specify
whether or not to have a warning beep to notify that an error occurs while reading a barcode.
You may specify pairs of “x y” other than the default “1E 07 00 05 1E 07”.
Vibrator
Specify how long the vibrator is turned on (in units of 0.1 second) to notify that an error occurs
while reading a barcode.
By default, the vibrator is turned off.
2.4 RESET
Click Reset to load the default settings. This applies to the following settings
Reader Settings
Barcode & Parameters
Advanced Settings
RFID Settings
Note: The current settings will be cleared.
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 86 87

Comentarios a estos manuales

Sin comentarios