CipherLab 1562 Guía de usuario descargar pdf (Pagina 11)

Introduction

HOW TO CONFIGURE THE SCANNER?

1) Run ScanMaster.exe on your computer.

2) Click the drop-down menu of [Select Scanner] on the toolbar, and select the scanner

you want to configure. If you are using ScanMaster for the first time, click to expand

the

Scanner Information by category so that the default settings of the scanner can be

viewed.

3) To create a new configuration file, click

or on the toolbar.

To open an existing configuration file, click

on the toolbar.

To clone configuration from another scanner, click Configure | Read Scanner

Settings. This scanner has to be connected to the serial port of the computer.

4) Proceed to configure the scanner. The data process is illustrated below.

1. The scanner will work with the settings specified on the Scanner tab.

2. It will read barcodes only if their symbologies are enabled, and output data in the

desired letter case as selected on the Symbology tab.

3. It will check one by one whether the read barcode meets the criteria set out for a

concatenation of barcodes on the Output Sequence tab.

4. It will perform character substitution as defined on the Format Editing tab.

5. It will add 2-digit length code to desired symbologies as selected on the Code

Length tab.

6. It will add 1- or 2-character identifier to desired symbologies as selected on the

Code ID tab.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 81 82

Sin comentarios

CipherLab 1562 Guía de usuario Pagina 11