CipherLab 1564 Especificaciones Pagina 178
- Pagina / 267
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
167
Update
Chapter 5
Definin
g
Output Format
5.2.1 SELECT A SET FOR CHARACTER SUBSTITUION
Configure Set 1
Configure Set 2
Configure Set 3
1) Read the barcode above to enable character substitution by set.
For example, read the “Set 1” barcode to configure the first set of character
substitution. The scanner will respond with one short beep, high tone, to indicate
more setup barcodes are required.
2) Read the “
Hexadecimal Value” barcode on page 252 for the desired character
substitution. For example,
KEY TYPE = NORMAL
Read “3”, “0”, “2”, and “D” to replace the character “0” with a dash “-”.
Read “3”, “0”, “2”, “D”, “3”, and “0” to replace the character “0” with a dash “-0”.
KEY TYPE = SCAN CODE
If you want to replace the character “0” with “a” (= “1C” on the scan code table):
1. Read “3” and “0”.
2. Read the “Scan Code” barcode.
3. Read “1” and “C”.
KEY TYPE = NORMAL + KEY STATUS = SHIFT
If you want to replace the character “0” with “!” (= “Shift” + “1” on keyboard):
1. Read “3” and “0”.
2. Read the “Add Shift” barcode.
3. Read “3” and “1”.
3) Read the “Validate” barcode to complete this setting. (The defined set or sets will be
applied to all symbologies by default.)
- 1664 Barcode Scanne 1
- IMPORTANT NOTICES 3
- RELEASE NOTES 5
- CONTENTS 6
- INTRODUCTION 12
- CHARGING THE BATTERY 14
- USING 3610 16
- SYMBOLOGIES SUPPORTED 18
- QUICK START 20
- ENTER CONFIGURATION MODE 22
- EXIT CONFIGURATION MODE 22
- Refer to Appendix III 27
- LIST THE CURRENT SETTINGS 28
- Chapter 1 32
- Turn on the scanner… 33
- Turn off the scanner… 33
- For Bluetooth 35
- 1.2 MEMORY 37
- 1.2.1 TRANSMIT BUFFER 37
- 1.2.2 MEMORY MODE 38
- 1.3.1 GOOD READ LED 41
- 1.3.2 GOOD READ LED DURATION 41
- Beeping 42
- Meaning 42
- 1.4.1 BEEPER VOLUME 43
- 1.4.2 GOOD READ BEEP 44
- 1.4.3 LOW BATTERY ALARM 45
- 1.5 VIBRATOR 45
- 1.5.1 GOOD READ VIBRATOR 45
- 1.6 SEND “NR” TO HOST 46
- 1.7 SCAN MODES 47
- 1.7.1 LASER MODE 47
- 1.7.2 AUTO OFF MODE 48
- 1.7.3 AUTO POWER OFF MODE 48
- 1.7.4 AIMING MODE 49
- 1.7.5 MULTI-BARCODE MODE 49
- 1.9 DELAY BETWEEN RE-READ 51
- Auto Power Off mode 51
- 1.12 NEGATIVE BARCODES 53
- 1.14 PICKLIST MODE 55
- 1.15 PAGER BEEP DURATION 55
- Bluetooth 55
- 1.16.3 DATE FORMAT 59
- 1.17 2D DECODE SETTING 60
- 1.17.1 AIMING PATTERN 60
- 1.17.2 DECODING ILLUMINATION 60
- 1.18 HARDWARE RESET 61
- 1.18.2 RESET CONNECTION 61
- Chapter 2 62
- 2.1 BLUETOOTH 63
- 2.1.1 ACTIVATE BLUETOOTH 64
- 2.1.2 RESET CONNECTION 65
- US Keyboard Style – Normal 67
- 67
- Cap Lock Type Description 69
- 2.1.4 INTER-CHARACTER DELAY 73
- 2.1.5 INTER-FUNCTION DELAY 73
- 2.2.3 ACK/NAK TIMEOUT 76
- Exit SPP Master Mode 78
- 2.3.2 INTER-FUNCTION DELAY 79
- 2.3.3 ACK/NAK TIMEOUT 80
- 2.4 USB HID VIA 3610 81
- 2.4.3 INTER-CHARACTER DELAY 90
- 2.4.4 INTER-FUNCTION DELAY 90
- 2.5 USB VIRTUAL COM VIA 3610 92
- 2.5.2 INTER-FUNCTION DELAY 92
- 2.5.3 ACK/NAK TIMEOUT 93
- 2.6 DIRECT USB HID 94
- *Capital Lock OFF 100
- Alphabet Transmission 101
- 2.6.3 INTER-CHARACTER DELAY 103
- 2.6.4 INTER-FUNCTION DELAY 103
- 2.7 DIRECT USB VIRTUAL COM 105
- 2.7.2 INTER-FUNCTION DELAY 105
- 2.7.3 ACK/NAK TIMEOUT 106
- Enter Setup 107
- Chapter 3 108
- 3.1 CONNECTING VIA 3610 109
- 3.1.1 CONNECT TO 3610 109
- “Set Connection” label 109
- “Serial Number” label 109
- 3.1.2 CHANGE INTERFACE 110
- Sniff Mode (Power-saving) 111
- 3.2 CONNECTING VIA BLUETOOTH 112
- DONGLE 112
- 3.2.1 CHANGE INTERFACE 112
- 103 114
- Authentication 114
- 3.2.3 CONNECT TO DONGLE 116
- 107 118
- 109 120
- Chapter 4 124
- 4.1 CODABAR 125
- 4.1.2 CLSI CONVERSION 125
- 4.2 CODE 25 – INDUSTRIAL 25 127
- 4.3 CODE 25 – INTERLEAVED 25 129
- 4.3.1 VERIFY CHECK DIGIT 129
- 4.3.2 TRANSMIT CHECK DIGIT 129
- 4.3.3 CONVERT TO EAN-13 130
- 4.4 CODE 25 – MATRIX 25 132
- 4.4.1 VERIFY CHECK DIGIT 132
- 4.4.2 TRANSMIT CHECK DIGIT 132
- 4.5 CODE 25 – CHINESE 25 134
- 4.7 CODE 39 136
- 4.7.1 VERIFY CHECK DIGIT 136
- 4.7.2 TRANSMIT CHECK DIGIT 136
- 4.8 TRIOPTIC CODE 39 139
- 4.9 CODE 93 140
- 4.10 CODE 128 142
- 4.11 GS1-128 (EAN-128) 143
- 4.11.1 TRANSMIT CODE ID 143
- GS1 DataBar Expanded 148
- Transmit Code ID 149
- Transmit Application ID 149
- 4.13.5 CONVERT TO UPC/EAN 150
- 4.14 MSI 151
- 4.14.1 VERIFY CHECK DIGIT 151
- 4.14.2 TRANSMIT CHECK DIGIT 151
- 4.15 EAN-8 153
- 4.16 EAN-13 154
- 4.16.1 CONVERT TO ISBN 155
- 4.16.2 CONVERT TO ISSN 155
- 4.18 UPC-A 157
- 4.18.2 TRANSMIT CHECK DIGIT 158
- 4.19 UPC-E 159
- 4.19.4 TRANSMIT CHECK DIGIT 161
- 4.20 CODE 11 162
- 4.20.1 VERIFY CHECK DIGIT 162
- 4.20.2 TRANSMIT CHECK DIGIT 162
- 4.21 COMPOSITE CODE 164
- 4.21.1 COMPOSITE CC-A/B 164
- 4.21.2 COMPOSITE CC-C 164
- 4.21.3 COMPOSITE TLC-39 164
- 4.22 US POSTAL CODE 166
- 4.22.1 US POSTNET 166
- 4.22.2 US PLANET 166
- 4.22.3 TRANSMIT CHECK DIGIT 166
- 4.23 UK POSTAL CODE 167
- 4.23.1 UK POSTAL 167
- 4.23.2 TRANSMIT CHECK DIGIT 167
- 157 168
- 4.24.5 UPU FICS POSTAL 169
- 4.25 2D SYMBOLOGIES 170
- 4.25.1 PDF417 170
- 4.25.2 MicroPDF417 170
- 4.25.3 DATA MATRIX 171
- 4.25.4 MAXICODE 172
- 4.25.5 QR CODE 172
- 4.25.6 MicroQR 172
- 4.25.7 AZTEC 172
- Chapter 5 176
- 177 188
- 181 192
- 5.4.2 CHANGE CODE ID 193
- 183 194
- 5.4.3 CLEAR CODE ID SETTINGS 196
- 5.5 LENGTH CODE 197
- 193 204
- Length Code for QR Code 204
- Length Code for MicroQR 204
- Length Code for Aztec 204
- 5.6 MULTI-BARCODE EDITOR 205
- Code Type 205
- Chapter 6 210
- 6.1.2 EXCLUSIVE DATA EDITING 212
- End Programming Format 213
- 6.2.2 RESTORE DEFAULT FORMAT 215
- 6.3.1 APPLICABLE CODE TYPE 216
- 6.3.2 DATA LENGTH 226
- 6.4.3 TOTAL NUMBER OF FIELDS 229
- 6.4.4 FIELD SETTINGS 230
- 221 232
- Field 3 Setting 232
- Field 4 Setting 233
- 223 234
- Field 5 Setting 234
- Additional Fields 235
- Key Type Key Status 235
- 6.4.5 PAUSE FIELD SETTING 236
- 227 238
- 6.6 PROGRAMMING EXAMPLES 239
- 6.6.1 EXAMPLE I 239
- 229 240
- SPECIFICATIONS 242
- Appendix I 244
- Click [OK] 245
- Appendix I Firmware Upgrade 246
- USING BLUETOOTH 247
- Appendix II 252
- Appendix II 254
- Host Serial Commands 254
- 3610 SERIAL COMMAND TABLE 255
- EXAMPLE 257
- Appendix III 258
- KEY TYPE & STATUS 259
- KEY TYPE 259
- KEY STATUS 259
- Appendix IV 262
- HEXADECIMAL SYSTEM 263
- ASCII TABLE 264
- USE PRESET PIN 265
- Reject Random PIN Request 267
Relacionado con productos y manuales para Lectores De Códigos De Barras CipherLab 1564
(174 paginas)
(277 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales