CipherLab 1661 Especificaciones descargar pdf (Pagina 27)

Update

Quick Start

READ A SETUP BARCODE

CONFIGURE PARAMETERS

For most of the scanner parameters, only one read is required to set them to new values.

The scanner will respond with two beeps (low-high tone) when each parameter is set

successfully. Refer to

Create One-Scan Setup Barcodes.

But for a number of special parameters, multiple reads are required to complete the

setting. In this case, the scanner will respond with a short beep to indicate it needs to

read more setup barcodes. These special parameters may require reading one or more

setup barcodes, such as

 Numeric barcodes, say, for keyboard type, inter-character delay, length qualification

 Hexadecimal barcodes, say, for character strings as prefix, suffix, etc.

 When “BT HID” or “USB HID” is configured for interface, Key Type and Key Status will

then become applicable. You may decide whether or not to change key status when

“Normal Key” is selected for Key Type.

To complete the configuration of these special parameters, it requires reading the

“Validate” barcode, and the scanner will respond with two beeps (low-high tone) to

indicate the input values are validated.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 234 235

Sin comentarios

CipherLab 1661 Especificaciones Pagina 27