CipherLab 1266 Manual de usuario descargar pdf (Pagina 5)

2.2 Power Up the 1166/1266 2.4 Charging your 1166/1266

When you receive your 1166/1266, the battery is separated from 1166/1266. Please

insert the battery into the bottom of the scanner and lock the battery by pushing the

clip to power on the scanner. The scanner will beep and the LED will be on when

power on.

There are three methods to charge the battery. One is placing the scanner on the

base and another is inserting the battery in front of the base, and the other is

inserting the power supply into the DC Jack at bottom of the scanner.

2.4.1

Scanner

ush up to lock the battery.

Please ensure to remove the battery to power off the scanner if it will not be used

for a prolonged period. The LED will be off and the power to the scanner will be

disconnected.

Place the scanner with a battery inserted on the base to charge your scanner. When

charging, the scanner LED will flash RED. When the battery is fully charged,

around 4 hours from completely empty battery, the LED stays on solid RED.

2.3 Setup RF Connection

2.4.2

Battery

Upon powering up the scanner will try to establish an RF connection with its base.

At this stage we need to “pair” the scanner and base.

Turn the base upside down and you will find 2 labels.

The first label has the words “SET CONNECTION” and a barcode. The second

label is the serial number.

To link the scanner to the base, scan the “SET CONNECTION” barcode label, the

scanner will beep once then scan the SERIAL number barcode. The scanner will

beep twice, low then high beep. When it establishes RF connection with the base

the scanner will then emit three short ascending beeps. Your “pairing” is

established.

Insert the battery in front of the base to charge your battery with the power adaptor

connected. When charging, the base charging LED will be RED. When the battery

is fully charged, around 4 hours from completely empty battery, the LED will be

solid GREEN.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

CipherLab 1266 Manual de usuario Pagina 5