Update & Exit Instruction Mode
CIPHER 1166/1266 WIRELESS BARCODE READER SETUP MENU
Disable ISBN-10 Conversion
Update & Exit Instruction Mode
Fax:- 088 322 7288
P.O. Box 855
Happy Valley S.A. 5159
www.datamanbarcode.com.au
The six configuration barcodes in the above column (2)
"RF-SHUTDOWN" are used to instruct the 1166/1266
barcode scanner to disengage the RF Shutdown sleep
mode. Usage and experience in the field has shown that
this RF-SHUTDOWN feature is not necessary for library
usage. It is however crucial that this sequence of
barcodes are read AFTER reading the barcodes in column
(1) and not before, if this order of reading is not followed it
will result in the shut down period defaulting to only 10
minutes.
When scanning the configuration barcodes it may be
necessary to proceed from barcode to barcode slowly to
allow time for each command to be processed internally by
the barcode reader. This requirement is most prominent
when scanning the first and primary barcode in the
column.
Proceeding through the column of barcodes too rapidly
can give erroneous results. Acceptable reading is usually
accompanied by an audible beep or succession of low /
high beeps.
It is still recommended that the power supplied from the
AC adaptor to the base station be periodically cycled to
effect a reset. This should be done at least on a daily
basis.
Comentarios a estos manuales