CipherLab 1266 Manual de usuario descargar pdf (Pagina 6)

2.4 Charging your 1166/1266

There are three methods to charge the battery. One is placing the scanner on the

base and another is inserting the battery in front of the base, and the other is

inserting the power supply into the DC Jack at bottom of the scanner.

2.4.1 Scanner

Place the scanner with a battery inserted on the base to charge your scanner. When

charging, the scanner LED will flash RED. When the battery is fully charged,

around 4 hours from completely empty battery, the LED stays on solid RED.

2.4.2 Battery

Insert the battery in front of the base to charge your battery with the power adaptor

connected. When charging, the base charging LED will be RED. When the battery

is fully charged, around 4 hours from completely empty battery, the LED will be

solid GREEN.

2.4.3 DC Jack

Insert the power supply to the DC Jack at bottom of the scanner. When charging,

the scanner LED will flash RED. When the battery is fully charged, around 4 hours

from completely empty battery, the LED stays on solid RED.

2.5 Interface Setting

Once you have “paired” the scanner and base, you need to specify the interface type

to your PC. The interface settings are stored in the base. So ensure that you have RF

connection between your scanner and base prior to setting the interface type. For

details on selecting interfaces please refer to the relevant section in this manual.

1 2 3 4 5 6 7 8 9 10 11 ... 54 55

Sin comentarios

CipherLab 1266 Manual de usuario Pagina 6