CipherLab 1266 Guía de usuario descargar pdf (Pagina 11)

Introduction

HOW TO CONFIGURE THE SCANNER?

1) Run ScanManager.exe on your computer.

2) Click the drop-down menu of [Select Scanner] on the toolbar, and select the scanner

you want to configure. If you are using ScanManager for the first time, click to expand

the

Scanner Information

by category so that the default settings of the scanner can be

viewed.

3) To create a new configuration file, click

or on the toolbar.

To open an existing configuration file, click

on the toolbar.

To clone configuration from another scanner, click Configure | Read Scanner

Settings. This scanner has to be connected to the host computer via RS-232 or

Virtual COM (BT SPP or USB VCOM).

Note: If you are using USB Virtual COM for the first time, you must install its driver from

the CD-ROM. Driver version 5.3 or later is required. Please remove older versions!

4) Proceed to configure the scanner. The data process is illustrated below.

1. The scanner will work with the settings specified on the Scanner tab.

2. It will read barcodes only if their symbologies are enabled, and output data in the

desired letter case as selected on the Symbology tab.

3. It will perform character substitution as defined on the Format Editing tab.

4. It will add 2-digit length code to desired symbologies as selected on the Length

Code tab.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 91 92

Sin comentarios

CipherLab 1266 Guía de usuario Pagina 11