CipherLab 1266 Guía de usuario descargar pdf (Pagina 27)

Chapter 1 Changing Scanner Settings

1.3 STATUS INDICATOR

1.3.1 BUZZER

The buzzer of the scanner beeps differently to indicate various operating conditions.

Select the check box if audible signals are not desired.

Conditions

Description

Power On Beep The scanner will generate a long beep to indicate it is turned on

successfully.

Good Read Beep The scanner will generate a beep to indicate it successfully reads

a barcode. You may select other frequency than the default 4

KHz.

Error Beep The scanner will generate a long beep in the lower tone to

indicate errors.

Enter Configuration Beep The scanner will generate 6 beeps upon entering the

configuration mode.

Update / Exit Configuration

Beep

The scanner will generate 6 beeps followed by one long beep

upon exiting the configuration mode.

Setup Beep In configuration mode, the scanner will normally beeps twice

when a setup barcode is read.

When a particular parameter needs to make use of more than

one setup barcode, the scanner will only generate a short beep to

indicate there are more setup barcodes that need to be read in

order to complete the current parameter setting.

Full Memory Beep For 1166 and 1266:

When "Memory Scanner" is enabled and the memory becomes

full, the scanner will sound a warning, 3 beeps in the lower tone.

1.3.2 GOOD READ LED

There is a dual-color LED indicator on top of the scanner. Normally, it is off except for the

following conditions:

Conditions

Description

Good Read LED turns solid red

Configuration Mode All models except for 1166 / 1266:

For 1166 / 1266 only:

LED turns solid green

LED turns solid blue

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 91 92

Sin comentarios

CipherLab 1266 Guía de usuario Pagina 27