CipherLab 1266 Guía de usuario descargar pdf (Pagina 24)

ScanManager User Guide

Continuous Mode

The scanner is always scanning.

 To decode the same barcode repeatedly, move away the scan beam and target it at the

barcode for each scanning.

Note: Refer to “Delay between Re-read”.

Test Mode

The scanner is always scanning.

 Capable of decoding the same barcode repeatedly, for testing purpose.

Laser Mode

The scanner will start scanning once the trigger is held down.

 The scanning won't stop until (1) a barcode is decoded, (2) the pre-set timeout expires, or (3)

you release the trigger.

Note: Refer to “Scanning Timeout”.

Auto Off Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout expires.

Note: Refer to “Scanning Timeout”.

Auto Power Off Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until the pre-set timeout expires, and, the pre-set timeout period

re-counts after each successful decoding.

Note: Refer to “Delay between Re-read” and “Scanning Timeout”.

Alternate Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until you press the trigger again.

Repeat Mode

The scanner is always scanning.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 91 92

Sin comentarios

CipherLab 1266 Guía de usuario Pagina 24