CipherLab 1562 Guía de usuario descargar pdf (Pagina 30)

ScanMaster User Guide

Continuous Mode

The scanner is always scanning.

 To decode the same barcode repeatedly, shift the scan beam away and target on the barcode

for each scanning.

Note: Refer to “Decode Delay” and “Delay between Re-read”.

Test Mode

The scanner is always scanning.

 Capable of decoding the same barcode repeatedly, for testing purpose.

Laser Mode

The scanning is activated as long as the trigger is pulled down.

 The scanning won't get deactivate until (1) a barcode is decoded, (2) the pre-set timeout

expires, or (3) you release the trigger.

Note: Refer to “Scanning Timeout”.

Auto Off Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout expires.

Note: Refer to “Scanning Timeout”.

Auto Power Off Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until the pre-set timeout expires, and, the pre-set timeout period

re-counts after each successful decoding.

Note: Refer to “Delay between Re-read” and “Scanning Timeout”.

Alternate Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until you press the trigger again.

Aiming Mode

The scanner will aim at a barcode once the trigger is pressed, and start scanning when the trigger

is pressed again within one second.

 The scanning won't stop until (1) a barcode is decoded, (2) the pre-set timeout expires, or (3)

you release the trigger.

Note: Refer to “Aiming Timeout”.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 159 160

Sin comentarios

CipherLab 1562 Guía de usuario Pagina 30