CipherLab 1562 Guía de usuario descargar pdf (Pagina 62)

ScanMaster User Guide

2.2.1 BAUD RATE

By default, it is set 9600 bps for 1500/1502, but 115200bps for 1504/1704 and 3656.

Select other value that matches your computer settings.

2.2.2 DATA BITS

By default, it is set 8 bits of data. Select 7 bits of data if necessary.

2.2.3 PARITY

By default, it is set no parity bit. Select other parity setting, even or odd parity bit.

2.2.4 STOP BIT

By default, it is set 1 stop bit. Select 2 stop bits if necessary.

2.2.5 FLOW CONTROL

By default, there is no flow control in use. Select the flow control (handshake) method.

Options

Description

No No flow control

Scanner Ready The scanner will activate the RTS signal upon powering on. After each good

read, the scanner will then wait for the CTS signal to become active. Data

will not be sent until the CTS signal becomes active.

Data Ready The RTS signal will be activated after each good read. The scanner will then

wait for the CTS signal to become active. Data will not be sent until the CTS

signal becomes active.

Inverted Data Ready It works the same as the Data Ready flow control, except that the RTS

signal level is inverted.

2.2.6 INTER-CHARACTER DELAY

By default, the inter-character delay is set to zero. Enter a value, ranging from 0 to 254

in units of millisecond, to match the computer response time of the RS-232 interface.

Such delay time is inserted between every character being transmitted. The longer the

delay time is, the slower the transmission speed will be.

2.2.7 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Enter a value, ranging from 0 to 254 in

units of millisecond, to match the computer response time of the RS-232 interface. Such

delay time is inserted between every function code (0x01 ~ 0x1F) being transmitted. The

longer the delay time is, the slower the transmission speed will be.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 159 160

Sin comentarios

CipherLab 1562 Guía de usuario Pagina 62