CipherLab 1562 Guía de usuario descargar pdf (Pagina 34)

ScanMaster User Guide

After establishing a WPAN connection successfully…

1. Once a WPAN connection is established successfully, the scanner stays active for a time (2

minutes by default) for data transmission. The CPU runs at full speed, and the LED blinks blue

(On/Off ratio 0.02 s: 3 s).

2. If the scanner is left idle throughout the active time (2 minutes by default), the scanner shifts

to inactive state to save power. The CPU runs at low speed, and the LED blinks red (On/Off

ratio 0.3 s: 2.5 s).

Press and hold the [Trigger] button to recover the scanner’s activity.

 There is no transition from full CPU speed to low CPU speed for Bluetooth HID and SPP,

however when the connection is based on a 3656 or 3610, the scanner will go through a

low CPU speed stage in order to save power.

 1664 is an exception from the said behavior. The 1664 goes through low CPU speed to

save power for Bluetooth HID and SPP

3. Being left idle, the scanner shifts to inactive state when it is the time (the Power-saving time).

Then the scanner keeps inactive and finally turns off with three short beeps, tone descending

from high to low, when it is the time (the Auto Power Off time).

Press & hold the [Power/Delete] button to turn the scanner back on. When the scanner

re-powers on, it attempts reconnecting to the host:

 For Bluetooth HID, the scanner resumes connection with the host upon powering on again

as long as the host application is still running. You will hear three short beeps, tone

ascending from low to high. If the scanner fails to resume the connection, it tries every 5

seconds unless the scanner reads the “Reset Connection” barcode.

 For Bluetooth SPP Slave Mode, the scanner must wait for the host to re-connect.

 For Bluetooth SPP Master Mode, the scanner resumes the connection with the host upon

powering on again as long as the host application is running. You will hear three short

beeps, tone ascending from low to high. If the scanner fails to resume the connection, it

tries every 5 seconds unless the scanner read the “Reset Connection” or “Restore System

Defaults” barcode.

 Interfacing with 3656 or 3610, the scanner tries re-connecting to 3656 or 3610 unless you

turn off the scanner.

1.2.2 POWER-SAVING

“Power-Saving” is provided for all scan modes. Set up a time (1~254 min.; 0= disable)

after power-on for the scanner to enter low-speed mode to save power. By default, the

scanner keeps active for 2 minutes after power-on and before entering low-speed

power-saving.

Note either of the following cases will set the Power-Saving inefficacious:

1) the interface is Bluetooth HID or SPP

(the 1664 is an exception to feature Power-Saving as usual),

2) the scan mode is set to Test, Continuous or Alternate Mode,

3) 1560/1564 is in Auto-Sense mode and seated in the Auto-Sense Stand, or

4) the setting value of Power-Saving is greater than that of Auto Power Off.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 159 160

Sin comentarios

CipherLab 1562 Guía de usuario Pagina 34