CipherLab 1562 Guía de usuario descargar pdf (Pagina 33)

Chapter 1

Changing Scanner Settings

1.2 POWER MANAGEMENT (1560/1562/1564/1660/1661/1664)

The Bluetooth-enabled models such as 1560, 1562, 1564, 1660, 1661, and 1664 feature

the management of power consumption. Such management enables the scanner to

control its power state in response to the input from the user. By the scanner’s power

management, the power consumption goes through the following transition:

1) The scanner stays active with full CPU speed right after power-on.

2) The scanner shifts to low CPU speed. (“Power-Saving”. See

1.2.2 Power-Saving)

3) The scanner finally shuts down. (“Auto Power Off”. See

1.2.3 Auto Power Off & 1.2.4

Auto Power off Ignoring Scan Mode (1560/1564)

Note there are a few eccentric cases:

 The “Power-Saving” is inoperative for the Bluetooth HID or SPP on all concerned

models except for 1664. The 1664 is able to deliver Power-Saving for Bluetooth HID

and SPP.

 For the 1661 and 1664 set to Direct USB for output, the “Power-Saving” and “Auto

Power Off” only comes to service when the USB cable gets loosened or connects

improperly.

1.2.1 BEFORE/AFTER BLUETOOTH CONNECTION

Before and after the Bluetooth connection is made, the scanner features similar power

managing mechanism. The following details how it is achieved.

Before establishing a WPAN connection successfully…

1. The scanner stays active for a time (2 minutes by default) attempting either of the following.

The CPU runs at full speed, and the LED blinks blue (On/Off ratio 0.5 s: 0.5 s).

(a) waiting for a connection request from the host (Bluetooth SPP Slave Mode)

(b) trying to connect to the host (Bluetooth HID or Bluetooth SPP Master Mode)

Note in the cases of (a) and (b), you may need to search for the scanner again on your

computer.

2. If the scanner fails to connect throughout the active time (2 minutes by default), the CPU

slows down and the scanner becomes inactive to save power. The LED starts to blink red

(On/Off ratio 0.3 s: 2.5 s).

Pull the scan trigger or press the scan button to resume the scanner.

3. Failing to make connection, the scanner shifts to inactive state when it is the time (the

Power-Saving time). Then scanner keeps inactive and finally turns off to conserve battery

power when it is the time (the Auto Power Off time).

Pull & hold the scan trigger or press & hold the [Power/Delete] button to turn the scanner

back on.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 159 160

Sin comentarios

CipherLab 1562 Guía de usuario Pagina 33