CipherLab 1562 Guía de usuario descargar pdf (Pagina 38)

ScanMaster User Guide

1.8 MEMORY MODE (1560/1562/1564/1660/1661/1664)

Memory mode is disabled by default. When the scanner is in memory mode, it means any

connection established with host is disabled.

The scanner keeps flash memory for memory mode operation.

 1560/1562/1661: 512 KB

 1564/1664: 4 MB

 1660: 256 KB

Warning: No connection is allowed unless the memory mode is disabled.

1.8.1 DATA DELAY

You may set a delay between each data record while transmitting data back to the

server.

1.8.2 SEND DATA & CLEAR MEMORY

When flash memory is run out, the scanner will respond with two short beeps (high-low

tone) as a warning. You are advised to send data to the server immediately by having the

scanner read the setup barcodes. Refer to a separate manual.

 For 1560/1562/1564/1660/1664, the scanner will resume the previous WPAN

connection with the host computer temporarily.

 For 1661 and 1664, the scanner can send data via “Direct USB” interface when the

cable is connected. Otherwise, it will resume the previous WPAN connection with the

host computer temporarily. When you connect the cable in Memory Mode, the scanner

is set to the output interface of “Direct USB Virtual COM” by default. Refer to

2.9.3

Secondary Interface for 1661

Unless you erase the memory by having the scanner read two setup barcodes – “Clear

Data” and “Confirm”, the flash memory won’t be cleared up even if the data is sent to the

host computer.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 159 160

Sin comentarios

CipherLab 1562 Guía de usuario Pagina 38